Renovation Videos

Fix it, build it, learn it.

Explore the video library

Every repair, build and renovation video, with the time, cost, tools and materials for each.

Filters

Filter videos

Room
All rooms
Room
Problem
Any problem
Problem
Skill level
Any skill level
Skill level
  1. How to Layout Iron Baluster Spacing on Staircase – Wood Tread & Handrail Spindle Layout

    Published: 7 Aug 2020

    Shows how to lay out 1/2 in. iron baluster locations on an open-tread staircase with white oak treads.

  2. Guest Bathroom Remodel: Turning a Tub Into a Tiled Shower

    Published: 29 Jul 2020

    A homeowner recaps a full guest bathroom remodel, converting a tub to a shower.

    Call a pro?
    Permit or a pro may be required
  3. Garbage Disposal Humming or Stuck? Troubleshoot, Then Replace

    Published: 25 Jul 2020

    A new-property owner troubleshoots a garbage disposal that does not spin, starting with checking outlet power, then the built-in reset breaker, then turning the motor with an allen wrench.

    Call a pro?
    DIY is fine
  4. Plumbing Benchtop Sanders to a 4 in. Dust Collector with Blast Gate

    Published: 20 Jul 2020

    Chris Marshall shows how he plumbed three benchtop sanders (disc, belt and spindle) to a 4 in. dust collector using a 4 in. to 2-1/2 in. StableGate blast gate, smooth 2-1/2 in. clear pipe, rubber…

    Call a pro?
    DIY is fine
  5. Fixing a Leaking Kitchen Sink Drain with New Putty and Washers

    Published: 8 Jul 2020

    A kitchen sink leak is traced to the drain strainer, where plumber's putty was cracked and a washer was not seated properly.

    Call a pro?
    DIY is fine
  6. Why Breakers Trip: Overloads, Ground Faults and Short Circuits

    Published: 15 May 2020

    A Chicago electrician explains the three main reasons a circuit breaker keeps tripping: an overloaded circuit, a ground fault, and a short circuit.

    Call a pro?
    Call a licensed pro
  7. Basement Stairs Makeover With Oak Plywood Treads for Under $200

    Published: 8 May 2020

    The creator turns unfinished basement stairs into finished ones for under $200 over 3 days.

  8. Filling Big Gaps with Backer Rod and Paintable Latex Caulk

    Published: 30 Apr 2020

    Vancouver Carpenter shows how to fill large gaps with latex caulking by first installing foam backer rod set about 1/8 under the surface.

    Call a pro?
    DIY is fine
  9. Door Won’t Latch? Three Fixes From Hinge Screws to Washers

    Published: 21 Mar 2020

    Three fixes for an interior door that won't latch because the latch and latch plate are misaligned.

    Call a pro?
    DIY is fine
  10. Kitchen Subway Backsplash: Tools, Cuts and Mortar Tips Explained

    Published: 11 Mar 2020

    Komar Project replaces a builder-grade kitchen's old backsplash with 2.5 x 8 inch textured subway tile.

    Call a pro?
    DIY is fine
  11. Toilet Water Stays in the Bowl: Clogs, Siphon Jet and Tank Parts

    Published: 4 Mar 2020

    A plumber explains why water can stay in the bowl when a toilet won't flush: a clog, hard-water buildup in the siphon jet, or worn tank parts like the flapper and fill valve.

    Call a pro?
    DIY is fine
  12. Building Plywood Built-In Shelves Under a Staircase

    Published: 27 Feb 2020

    Mr. Build It builds plywood built-in shelves for the area under a staircase, using 3/4 inch maple plywood, mitered face frames and wood glue.

    Call a pro?
    DIY is fine
  13. Smart Thermostat on Old Two-Wire Wiring: Reusing the Wall Wires

    Published: 3 Feb 2020

    Richard Trethewey replaces a 1962-era two-wire thermostat with a smart thermostat without running new wires.

    Call a pro?
    DIY is fine
  14. Tiling a Shower Wall: Cement Backer Board, Membrane and Thinset

    Published: 1 Feb 2020

    The video shows how to tile a shower wall as part of a bathroom remodel: removing the old tile, replacing the backing with cement backer board, waterproofing it, and setting, grouting and sealing…

    Call a pro?
    DIY is fine
  15. Easy Drywall Patch for Beginners: Plywood Backing and Mesh Tape

    Published: 28 Jan 2020

    A carpenter shows a beginner-friendly way to patch a hole in drywall, from scoring and snapping a new piece to screwing it to plywood backing, taping with fiberglass mesh, applying several coats of…

    Call a pro?
    DIY is fine
  16. Ceiling Light in a 1960 House: Why 60°C Wire Is a Fire Risk

    Published: 27 Jan 2020

    Master electrician Heath Eastman helps a homeowner whose new ceiling light carries a warning for houses built before 1985.

  17. Epoxy Garage Floor: Grind, Prime, Roll and Seal a 750 sq ft Slab

    Published: 17 Jan 2020

    A contractor shows how his crew coats a roughly 750 square foot garage floor with a tinted 100% solids epoxy.

  18. Patch a Hammer-Sized Drywall Hole: Cut, Tape, Mud and Texture

    Published: 12 Jan 2020

    A hole is made in a wall and then repaired start to finish.

    Call a pro?
    DIY is fine
  19. Running Toilet: Telling a Bad Fill Valve from a Worn Flapper

    Published: 6 Jan 2020

    A Home Depot Canada tutorial on stopping a running toilet.

    Call a pro?
    DIY is fine
  20. Replace a Dishwasher: Water, Power, Drain and Leak Test

    Published: 22 Jul 2019

    Plumber Roger Wakefield removes an old dishwasher and installs a new stainless steel one in his own kitchen.

    Call a pro?
    DIY is fine
  21. Floating Deck Around a Tree: 14×14 Build on Concrete Deck Blocks

    Published: 13 Jul 2019

    A contractor builds a 14 ft by 14 ft floating deck about 12 inches above the ground around a tree.

    Call a pro?
    Permit or a pro may be required
  22. Replacing Worn Oak Stair Treads and Covering Pine Risers

    Published: 5 May 2019

    Tom Silva of Ask This Old House shows a homeowner how to replace loose, cracked, noisy split-level stair treads with new red oak.

    Call a pro?
    DIY is fine
  23. Door Won’t Latch: Three Strike Plate Fixes, Easiest to Hardest

    Published: 28 Mar 2019

    A bathroom door that will not latch is fixed three ways, from easiest to most involved: tapping down the strike plate lip, filing the strike plate, or repositioning the whole plate lower.

    Call a pro?
    DIY is fine
  24. Vertical Shop Vac Cart with Dust Deputy Cyclone, Built from Plywood

    Published: 11 Mar 2019

    A woodworker builds a vertical dust collection cart from 3/4 in. Baltic birch plywood to hold a shop vac with an Oneida Dust Deputy cyclone and bucket on top.

    Call a pro?
    DIY is fine