Most covered this month
Shed to Workshop Conversion
Mike Montgomery of Modern Builds starts with a shed that has decent bones but a lot of problems: a worn floor, a wall and door close to falling off, a…
New in the library
Delta Shower Cartridge: Removing a Stuck One and Reinstalling
Shows how to replace a Delta shower and tub cartridge when the shower head or tub spout drips constantly.
Home Repair HubAdded 3 Nov 2026Replacing a Thermostat: Four Types and the Steps to Install One
The Home Depot explains the four main thermostat types (non-programmable, programmable, Wi-Fi and smart) and shows how to replace an existing thermostat.
The Home DepotAdded 3 Nov 2026Replacing a Dishwasher: Power, Water, Drain Line and Air Gap Steps
Jackie from Lowe's walks through removing an old dishwasher and installing a new one.
Lowe's Home ImprovementAdded 3 Nov 2026Replacing a Ceiling Light Fixture: Breaker, Wiring and Mounting
A step-by-step guide to swapping an old ceiling light fixture for a new Inlight fixture.
LRN2DIYAdded 3 Nov 2026Replace a Toilet Fill Valve With a Fluidmaster 400H in 15 Minutes
Shows how to fix a running toilet by replacing the fill valve with a Fluidmaster 400H.
Home Repair TutorAdded 3 Nov 2026Unclog a Toilet With Dish Soap and Hot Water, No Plunger
A demonstration of clearing a blocked toilet without a plunger, using dish washing detergent and hot water.
DIYForKnuckleheadsAdded 3 Nov 2026
Popular jobs
All topics
Solar Shed 2.0
Scott of Everyday Home Repairs extends the roofline of a 12x16 modern single-slope shed…
Fireplace with Built-ins
Part 2 of a fireplace project shows how built-ins with storage were added beside…
Guides
All guidesBuilding a Paver Walkway: Locates, Base, Sand, Pattern and Joints
A paver walkway is mostly what is under it. Find the buried lines first, build a compacted base, screed the sand, and lock the joints at the end.
Setting Up a Workshop in a Shed: Floor, Walls, Light and Power
A shed workshop is built from the floor up and the outside in. Fix what is leaning, level the slab, let light in, insulate without choking the roof, then finish the walls and floor, and leave the power to an electrician.
Baseboard and Crown Moulding: Measuring, Mitering and Nailing
Trim looks wrong when the corners are not 90 degrees. Check each corner first, adjust the miter angle to match, nail into wood and fill what is left.